Home > Hard Drive > Can I Swap In A Hard Drive From Another Computer Temporarily?

Can I Swap In A Hard Drive From Another Computer Temporarily?

Contents

If that is the case you may disconnect the old drive or use it for storage purposes.TipsMacrium Reflect works well with encrypted drives as it does not need to run operations However, that is not necessary. Getting the drive out of the old PC is usually pretty easy, even on a laptop, but trying to then transplant that drive into a new machine presents a whole new Then do an "ifup ethX", replacing X as necessary, and see if the interface comes up. this content

But the Reflect front end is much easier to use, so once again I returned to Reflect. Is there a way to ensure the BitLocker To Go Reader is not installed on FAT-formatted drives? If you were using an on-board NIC, again, you may need to reconfigure it and load new drivers. Raw data is encrypted with the full volume encryption key, which is then encrypted with the volume master key. http://www.sevenforums.com/hardware-devices/257626-can-i-swap-hard-drive-another-computer-temporarily.html

Can I Put My Hard Drive In Another Computer

Important You should ensure that BitLocker has finished the encryption process on your drive before attempting to view the drive by using the BitLocker To Go Reader. Characters that are not available in 7-bit ASCII. If it was there by itself, it will have been set to Master, and need to be changed to Slave. Your card, whatever it is, will act like a basic VGA card when Windows does this.

For more information about enhanced PINs see What is the difference between a TPM owner password, recovery password, recovery key, PIN, enhanced PIN, and startup key? Will I need to re-enter keys for Microsoft office and such (which I don't have anymore) or will it basically be as if I never removed it, and I simply need I thought I still had the dock box, but I can't find it right now. Swapping Hard Drives Between Computers I had to take the computer to a tech.

Make sure you have enough a spare power connector and SATA data cable as you need those to connect the new hard drive.If you don't, you may use existing cables instead, Putting An Old Hard Drive Into A New Computer This means that if a portable computer is connected to its docking station when BitLocker is turned on, then it might also need to be connected to the docking station when Can I run a kernel debugger with BitLocker? http://www.tomshardware.com/forum/250347-32-transferring-hard-drive-computer All my pinned apps on the taskbar were gone, no big deal to re-pin them.

What happens? Does Removing Hard Drive Remove All Data NOW you have a "Perfect" HDD to install to.So, if you do that, THEN you replace the Seatools CD with the Win 8 Install CD and do the Installation.HOWEVER, there is Another curiosity. After you have determined your TPM's manufacturer (see How can I determine the manufacturer of my TPM?), contact the manufacturer to gather the TPM's vendor-specific information.

Putting An Old Hard Drive Into A New Computer

If so that would be awesome.Essentially, whenever I tell told Acronis to copy a SOURCE windows disk, into a LARGER partition space on the DESTINATION DISK (if the destination disk was original site RELATED ARTICLESHow to Recover Files From a Dead ComputerHow to Convert a Physical Windows or Linux PC to a Virtual Machine Windows really isn't designed to be moved between hardware without a Can I Put My Hard Drive In Another Computer In Windows 7, you can configure the minimum personal identification number (PIN) length by using the Configure minimum PIN length for startup Group Policy setting and allow the use of alphanumeric PINs Adding Old Hard Drive To New Computer Mount drive b in computer 1 as replacement for drive a.So what is new?

Enhanced PINs are PINs that use the full keyboard character set in addition to the numeric set to allow for more possible PIN combinations and are between 4 and 20 characters http://gbcmedina.com/hard-drive/problem-with-new-computer-seeing-the-hard-drive.php The enclosure is a very convenient was to temporarily connect to old drives. The reply is currently minimized Show Accepted Answer yaye Offline Thursday, November 10 2011, 09:54 PM - #Permalink Resolved 0 votes Just in case you forgot, make sure the on board Short of driving halfway across town to see if it connects to their modem, how can I check what's going on? Moving Hard Drive To New Computer Windows 10

Have recovered quite a lot over the years since I bought the cables. When using an enhanced PIN, users should run the optional system check during the BitLocker setup process to ensure that the PIN can be entered correctly in the pre-boot environment. Cost: $25-$50 These are all the ways I can think of, though if your new machine is a desktop you may want to look at our guides to physically installing a have a peek at these guys When it's done and you are all ready to wipe all the old data off, you must be sure the BIOS Setup system is adjusted to boot first from the optical

On my current laptop, which has SATA II ports, it takes a little over three and a half hours. Transfer Hard Drive To New Computer Without Reinstalling Windows It would be great thing if drive a could be copied to drive b while it was running. Fixed data drives can be set to automatically unlock on a computer where the operating system drive is encrypted.

If you are going to try that, I would suggest you disconnect your new drive first, so there is no possibility the Repair Install will do anything to your new drive.

Upgrading What versions of Windows 7 include BitLocker? The reply is currently minimized Show Accepted Answer Tony Ellis Offline Wednesday, November 09 2011, 02:17 PM - #Permalink Resolved 0 votes I suspect a major obstacle to doing this move Subscribe to Our Newsletter Email: Advertisement Scroll down for the next article © 2017 MakeUseOf. Move Hard Drive To New Computer Windows 7 Won't Boot If you’re me, then this. –Synetech Aug 29 '12 at 15:54 Note that hard drives are one of the first parts on a computer to wear out.

The following list identifies characters that are not currently supported by system firmware: Roman characters on keyboards with a non-EN-US keymap. I don't plan to use it for long as I plan to buy an MX200 once it becomes available again. This system check performs tests to confirm that the computer can properly read from the USB devices at the appropriate time and that the computer meets other BitLocker requirements. http://gbcmedina.com/hard-drive/hard-drive-partition-can-t-be-seen-in-my-computer.php This cuts down my options quite a bit - is it possible to post-install the graphical console from the command-line with no internet connection available?

This copies all contents of that drive to the destination drive.Click on "select a disk to clone to" on the next screen, and pick the new drive. What type of disk configurations are supported by BitLocker? He is passionate about all things tech and knows the Internet and computers like the back of his hand.You can follow Martin on Facebook, Twitter or Google+ View all posts by It is slow to convert, but it means you can grab anything back after mounting the VHD using the windows Drive Manager.

I got one for $12.99. This can prevent the entry of enhanced PINs. This value is never displayed to the user. Should I be concerned that swap is being used on a host with nearly 40GB of free memory?

In addition, you must use a Microsoft-provided TPM driver. Macrium Reflect doesn't automatically restore a destination drive's original volume label after cloning to it, so you have to remember to do it manually.) Reply Mike S. How does it work? When implemented, this option can make the TPM hidden from the operating system.

Just one thing, though: Windows Explorer can really bog down when listing and sorting the contents of folders that contain a huge number of top-level files (i.e., not including files in In these situations, you must be able to supply either the recovery key or the recovery password to unlock the encrypted data on the drive.